Home   Materials     Formulated Liquids     Molding Powders     Coating Powders     Films & Preforms   Equipment     Meter, Mix, Dispense-Liquids     Transfer Molding Presses     Fluid Beds     Electrostatic Coating   Tooling     Transfer & Compression     Spiral, Flash, Prototype   Applications     Representative Examples     White Papers   Customer Request   FAQ     Conversion Tables     Engineering Data     Formulated Liquids     Molding Powders     Coating Powders     Films & Preforms   Associates     Don Hickson     Steve Ellis     William Smith, Jr.   Contact Us

Coating Powders Coating Products are available in a variety of formulas.  Material properties can be fine tuned to a particular application.   The following is an abbreviated, general selector guide to illustrate a variety of available materials.  There a numerous other formulations available to meet your needs, but space precludes listing them.   Contact us via Email or through the "Customer Request" link for personal assistance in selecting the appropriate material and process for your application.     CP1 CP2 CP3 CP4 CP5 CP6 CP7 CP8 CP9 CP10 Chemistry epoxy epoxy epoxy epoxy epoxy epoxy epoxy epoxy epoxy epoxy Deposition Electrostatic Electrostatic Fluid Bed Electrostatic Fluid Bed Fluid Bed Fluid Bed Fluid Bed Electrostatic Fluid Bed Color Blue Blue Blue/Gray Green Blue/Black Tan Blue/Gold Red Satin Black Black/Blue Preheat Temperature None None 200°C None 200°C 200°C 125°C 200°C None 200°C Cure 20 min @ 200°C 10 min @ 200°C 7 min @ 200°C 10 min @ 200°C 15 min @ 230°C 5 min @ 170°C 30 min @ 150°C 5 min @ 170°C 2 min @ 200°C 15 min @ 200°C Gel Time 60 seconds 38 seconds 20 seconds 6 seconds 48 seconds 11 seconds 20 minutes 50 seconds 52 seconds 50 seconds Cut-Thru Temperature 380°C 360°C NA 345°C NA NA NA NA NA NA Edge Coverage (%) 30 33 40 68 45 40 30 45 45 45 Glass Plate Flow 27mm 20mm 25mm 20mm 27mm 20mm 30mm 20mm 41mm 20mm Impact Strength 140 in-lbs min 140 in-lbs min >160 in-lbs >160 in-lbs 150 in-lbs 140 in-lbs min NA 140 in-lbs min 160 in-lbs >160 in-lbs                       Electrostatic deposition X X   X         X   Convection oven cure X X X   X X X X X X Induction coil cure       X             Fluid bed dipping     X   X X X X   X                       Notes: 1 1 2 3 4 5 6 7 8 9                         ---- Top ----   Notes:    1.  High cut-through for electrical motor insulation    2.  Fast curing powder for distribution transformers, cans    3.  High cut-through, Fuel resistant motor iron coating    4.  Low voltage bus bar coating, UL approved electrical insulation (30mils)    5.  Low & medium voltage bus bars, UL approval (>60 mils)    6.  Low temperature fusing coating powder (125°C)    7.  Medium voltage bus bars (>60 mils)    8.  Automotive underhood yokes (2 - 5 mils)    9.  High performance, low voltage bus bar coating, (>30 mils)   © 2007 - 2009 Hickson and Associates, Inc. All rights reserved   Website Design by Kentron,Inc.